C 	    --------------- 1ST_README.TXT ------------------------------- > 	This file explains how to set up and run the DECtalk-Telecomm 	demonstration program.   + 	CONNECTING THE DECTALK TO THE MicroVAX II  D 	-------------------------------------------------------------------< 	1.  Log into the account on the system containing the demo.  > 	2.  If the Archer 4 line tap telephone adaptor is being used,9 	    the "free ends" of the two RS232 cables connected to 7 	    the MicroVAX II or the VAX should be connected to  A 	    DECtalk module 1 (connector J1) and module 4 (connector J4).      ? 	3.  The Archer 4 line tap telephone adaptor (from Radio Shack) @ 	    only runs 2 telephone lines.  LINE 1 on the Archer Line Tap? 	    is for the demo running on DECtalk module 1 and LINE 2 on  E 	    the Archer Line Tap is for the demo running on DECtalk module 4.   < 	4.  Modify the configuration file (telecomm.cfg) to contain= 	    the terminal lines that the RS232 cables for each of the = 	    DECtalk demos is connected to on the MicroVAX.  That is, : 	    if the DECtalk module running the "telecomm" demo is ? 	    connected to terminal line "txb0:", then the configuration & 	    file (telecomm.cfg), should read:  
 	    TXB0:  = 	5.  Set the device protection of each of the terminal lines  < 	    specified in the configuration file to WORLD READ/WRITE 	    access.  3 	    For example, for the above configuration, type   ) 	    $ set protection=(w:rw)/device txb0:   ; 	    (consult the DCL manual for more detailed information)   A 	6.  To start up the demos, enter the following two DCL commands:    	    $ set proc/priv=all 	    $ @telecomm telecomm.cfg   C 	8.  The following will come back after these commands are entered:   B 	    %RUN-S-PROC-ID, identification of created process is 00000xxy  < 	    which indicates that the DECtalk demo has been started.  A 	9.  If you enter the DCL command, "show system" you should see a > 	    process with the name "DEMO_txxy" in the listing.  Note, E 	    "txxy" is the terminal line that the DECtalk module is connected C 	    to on the MicroVAX.  If this process name is missing, then the A 	    demo has stopped running because some error has occured.  To B 	    see which errors have occured, type the error file "txxy.err"= 	    where "txxy" is the terminal line the DECtalk module is   	    connected to.  = 	10. If you want to stop running the demo enter the following  	    DCL command:    	    $ stop demo_txxy   = 	    where "txxy" is the terminal line the DECtalk module is   	    connected to.  ? 	11. After the process has been stopped, type the following DCL 
 	    command:    	    $ copy TXyy: nla0:   : 	    where again, "TXyy:" is the name of the terminal line> 	    that the DECtalk is connected to.  After about 5 seconds,< 	    press either CTRL/C or CTRL/Y.  (The copy command hangs> 	    until either of these commands is entered).  Pressing the; 	    CTRL/C or CTRL/Y should cause the DCL ($) prompt to be  	    displayed again.   